Results 1 to 1 of 1
  1. #1

    Question Should I replace the motor?

    Good morning,
    I bought a nema23 stepper motor from a website called steppermotor, driving it using an L298n module with a supply voltage of 12V DC and 2A, but the operating torque is very weak and it does not lock.
    After owning an Ender 3 3D printer with the same motor, I realized that the motor was not necessarily the source of the problem.
    Will switching to a TMC2208 type driver or another driver (I await your advice) increase the torque of the motor? Is the problem with my supply voltage? Should I replace the motor?
    Last edited by Bikeracer2020; 12-01-2023 at 09:12 AM. Reason: persistent link posting

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts