I do apologize, you are correct. I am just comparing this forum with other car related forums I am in, they are very active. I dont use any forums often at all but the other I do I get an answer quickly. I can't assume all are the same way. But thank you very much for letting me know and I hope you forgive me.

I didn't think any of that other info you stated was important. All of it is default. And it wasn't only when I printed my own design. So let me start over, because the problem has changed. I tightened the nozzle where the filament goes into and re-leveled the bed. I was able to print. There's a new problem that I don't know if I should start a new thread or not because I feel bad and guilty about what I've done, but I'll give it a try.

Again, I apologize.