My useless trinkets 2

[OG56]

Was thinking of making a Halloween lamp shade and complete failure due to the filament I had available. Too opaque and doesn't allow any light through. Oh well, on to the next project.

[OG56]

Model made for my wife's social media channel.

[OG56]

Test print of my next big project. This is still just the base mesh. It helped to print it to see where all the issues were lurking. Need to thicken the wings and the fingers so they don't snap with the supports. It will be printed in multiple parts.

I need to take it into a digital sculpting software to add the detail.

[OG56]

A quick 3d sculpting project for practice and fun.

[OG56]

Now one of my top 3 favorite models. Still need to sand, fill in cracks and prime before paint. Printed in 7 parts. 16 inches tall and about 19 inches wide.