Results 1 to 4 of 4
Thread: Seams reduction on radii \ domes
Threaded View
-
08-08-2023, 01:23 AM #2
- Join Date
- May 2020
- Posts
- 622
Set the slicer to variable layer height, this should help but not eliminate the gap problem by making the layer height thinner where a curved surfaces occurs.
The seam appears because of the layer change, there will be a setting to change this to variable positions rather than at the back. But then you might get zits instead.
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials