Results 1 to 2 of 2
-
05-08-2023, 12:08 PM #1
- Join Date
- May 2023
- Posts
- 2
Need help setting Z = 0 in Kelant C60 Mono
Hi all,I need some help setting Z=0 in my Kelant C60 Mono. I have leveled the bed with paper, and now I am trying to set the current position as Z=0. Please bear in mind that this is my first resin print try out ever.The issue is that when I tap the option "Set Z=0", it instructs me to "Home first, then move Z to the bottom." (attachment), even though I have already been doing this. As per the message, I understand that the current position is not set as Z=0, and I can't figure out how to make this work. What could I be missing here? Is my understanding about "Set Z=0" correct, i.e., "take the current Z position and never go below it."?Thanks in advance!
Last edited by jgmelo@gmail.com; 05-08-2023 at 12:16 PM.
-
05-12-2023, 01:28 PM #2
- Join Date
- May 2023
- Posts
- 2
Resolved.
Resolved. If you are a beginner in resin 3D printing, make sure to *remove*, not loosen, the bed levelling screws before levelling and *homing*.
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery