Results 1 to 2 of 2
Threaded View
-
05-22-2023, 07:00 AM #2
- Join Date
- Nov 2022
- Posts
- 18
Did you ever get this fixed?
I see over 1100 reads, but no replies.
A little more info would help like what material, temp, and slicer used (and did you check and see if supports are required).
You can rule out a mechanical issue by printing something simple like a cube stretched in the z axis a little taller than where your print is messing up.
If that prints ok, then you can most likely rule out any mechanical issues, and look into slicer settings.
ABS Sticking to Build Plate
10-20-2024, 05:02 PM in 3D Printer Parts, Filament & Materials