Trying to make letters of the Alphabet

[fred_dot_u]

Rather than firing up F360 again, I loaded the full STL into Meshmixer and did a "separate shells" then exported each letter to its own file, attached for your viewing pleasure. It's very likely your slicing software could separate the individual letters, but you didn't mention what program you're using and I don't know all the features of all the slicers.

Keep in mind that there's no need to apologize for being new. One must start somewhere.

[carlberry64]

Rather than firing up F360 again, I loaded the full STL into Meshmixer and did a "separate shells" then exported each letter to its own file, attached for your viewing pleasure. It's very likely your slicing software could separate the individual letters, but you didn't mention what program you're using and I don't know all the features of all the slicers.

Keep in mind that there's no need to apologize for being new. One must start somewhere.

I am useing Cura sorry should have said.