Artillery Sidewinder X1 won't turn on. (video)

[ada]

235V going into the PSUA steady 24.3v DC coming out. --- I wouldn't suspect the power supply is bad unless it's spiking for some reason. -- So you may be right, just a bad driver. That leaves me with a few questions before I swap out the driver. 1. Would a bad driver cause the entire machine to turn off? I would guess it would stop printing and just display an error if it was just the driver. 2. What would cause the driver to go bad? It's the Y axis driver that burnt out. The cable from the driver to the stepper motor is fixed and is perfectly fine. The motor turns fine with no resistance. -- Here's an image of the bad stepper -- https://ibb.co/VmR3zRr

Did you find what was broken?. I think I have exactly the same issue, but I can't figure out what I need to change?

Thanks for your help

[Roberts_Clif]

I know the IC is bad and a couple other components though decided my time was worth more than the cost of a controller board that could be programmed to take its place.