X400 DIY Special offer kit (buildup)

[Luchador]

So I finished checking and readjustemnt of the frame yesterday

IMG_8086.jpgIMG_8088.jpgIMG_8089.jpg

I checked every adge in every direction readjust if neccessary and checked again all until all point were in the right angel and flat to the other profiles.
(The Block is a grinded part with perfect 90° angles and absolut flat a realy helpful tool)

I also insert the spindel holder and spindels
holders plate and the plate themself
IMG_8092.jpgIMG_8100.jpg

2 Point I need to double check today

One screw I destroy ,
Pulley of the spindle so I need to remove it again to change the screw.

and one of the holders plate (sinter parts) has a too small hole so I need to drill it to right size today , ( I propose to check all holes of the sinter parts before sometimes they are a bit to small)

if this is finished I can fix the plate and start the first fine adjustment of the plate position ( make it even to the frame)

so more hopeflully this evening

so far around 5 hours work include preparation not difficult yet,
but you need to work realy correct (special on the frame) to get all in the right angle a third hand would be good (its possible alone but need more time)