first sorry for so long no news but I was a bit busy so no time to go on, additional I have a small issu with the transfer of the pic to the computer

I hope to solve the issue with the pics tommorow han can give you a lot of new views.

What I did today was uploard the firmware and check the first points

so far thermistor headbed and the heatbed themselve are working

with my ground adjustement of the Polols Z is working good so far only a seldom sound is hearable but this could be also bec the spindles are dry at the moment this will check later.

after readjust my Y belts this is also working.

X was making trouble but after a while ( sitting in front and not understanding anything anymore ) i get it , stupid issue from my side I connected the motors like i do usual but here the motors need to run in opposide directions ,
after the connector was turned the X is now also moving.

I´ll sit don now I try to finish the Hotend (thermistor and heater not connected yet)

Will update tomorrow plan would be to finish all and start calibration.

br
Thomas