Results 1 to 2 of 2
  1. #1

    CR Touch Bed Leveling System Help with Ender 3 Pro

    I have an Ender 3 pro and I just installed the CR touch bed leveling system. When I set the z offset and then start a print, it doesn't work, the tip is either too close or too far from the bed. It isn't working at all how it is supposed to. Is it the firmware? What am I missing? Any suggestions are greatly appreciated.

  2. #2
    Lots of views on this but no replies, just wondering if anyone out there has experience with this bed leveling system and could help.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts