Close



Results 1 to 3 of 3
  1. #1

    Question Printer start printing offset by X and Y

    I bought Cobees III mini printer. The printer start printing offset by X and Y about 10 mm. Where in marlin configuration file can change the value?
    Attached Images Attached Images
    Last edited by omnilog; 09-24-2022 at 03:45 PM. Reason: wrong explanation

  2. #2
    Super Moderator
    Join Date
    May 2020
    Posts
    441
    Have you configured the correct bed size into Cura ?

    If the printer comes with its own slicer, perhaps try that first.

  3. #3
    After a lot of read I found solution adding G92 X10.3 E0 and G92 Y-10.3 E0 to start g-code in Cura.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •