Subscribe to Our Newsletter Advertise
Close



Results 1 to 6 of 6

Threaded View

  1. 02-26-2023, 02:14 PM #6
    DanJustDan
    DanJustDan is offline
    Student
    Join Date
    Feb 2023
    Posts
    1
    I ran into this a few days ago on one of my first prints. Turns out the skirt was falling outside of the printable surface. Turn that off in the settings and you may be good to go.

    Heh. New guy should probably look at the post dates...
    Last edited by DanJustDan; 02-26-2023 at 02:16 PM. Reason: Addition
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules