3D printing ideas

[OG56]

I've had my first 3d printer for about 2.5 months and I am finally giving it a small break. It was running 24/7 for about 2 months straight. I have many dozens of prints now under my belt but still very much a newbie at 3d printing. So far, about a dozen failures, all due to my poor model designs.

I've been 3d modeling for about 9 years and I have a library of models that are potential 3d prints. None of them are perfect so they would take some degree of work to get them 3d print ready.

For inspiration I do look at what other folks are making. There are so many amazing artists out there. Since I can 3d model, I also look at 2d stuff.

This is my very first print. I skipped all the calibration prints and went with my model. It is printed 6 inches tall at .2mm with 20% infill and automatic supports.