Results 1 to 6 of 6
Thread: I have some bsic questions
Hybrid View
-
08-07-2022, 01:12 AM #1
- Join Date
- May 2020
- Posts
- 622
Perhaps if you go down the keel and bulkheads route it might be better to make the bulkheads undersize to allow to plank the surface for a mould plug, rather than fill in between the bulkheads with foam or balsa.
I think planking sanded smooth would give you a better uninterupted surface than filling between the bulkheads and then sanding smooth.
However, either way could see you with a lot of work to get the surface you're after for moulding a display model and it might be better to just carve from solid.
Anyway I wish you luck and hope you'll post the results here.
Please explain to me how to...
05-13-2024, 03:08 PM in 3D Printer Parts, Filament & Materials