Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 10

Thread: Wierd problem

Hybrid View

  1. 08-28-2014, 03:33 PM #1
    DrLuigi
    DrLuigi is offline
    Super Moderator DrLuigi's Avatar
    Join Date
    Oct 2013
    Location
    Belgium
    Posts
    502
    Well monitor your temprature, The chance is pretty big that its going below 170c wich is the minimum set in the Makerfarm printers in the Marlin software.
    When it goes below 170c and doesnt go up again, it will simple quit printing (extruding).
    Reply With Quote Reply With Quote
  2. 08-28-2014, 03:45 PM #2
    Melzk
    Melzk is offline
    Student
    Join Date
    Aug 2014
    Posts
    9
    Hum now when you say that maby my printer sent down to 169C in one time. But i think it was after it stopped the extruder
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules