Wierd problem

[Melzk]

i checked the code and slicer and it only uses one extruder.
but it must be som error with my gcode.

are there any software that i han test to emulate a print with?

[printbus]

are there any software that i han test to emulate a print with?

You can view what the printer will do using a viewer like http://gcode.ws/. Click on the layer info button and then move the slider on the far right up and down to review each layer. The bottom slider can be moved to follow the head move throughout the selected layer.

Is it intentional that all the layers are 0.35 or 0.4mm in height?

[Melzk]

Yes it is just a "raw" prototype i printing out. Usually i print in 0.1 but 0.4 for prototyping

[Melzk]

Mrluigi had right it was the temeratur sensor that stoped the print so now i puted my fan in the fan jacket so i can adjust the fansped