Qidi x-one failing with larger files

[kaotkbliss]

I had the printer shut off most of the day yesterday and all night and now the symptoms changed a little. The first print which I didn't get a video of printed almost the entire first layer before it stopped advancing the filament. I then ran it again, 2 more times and got the videos for both:
https://youtu.be/7XwexprWnWM
https://youtu.be/fAUvXoLnSP4

*edit*
When the issue first came up and I had a few failed prints in the exact same spot in the exact same way, I thought it may have been a corrupted gcode file so I respliced and retried a few times, even used a different SD card but nothing changed. That's when I went to testing the block that had previously worked before this.

[kaotkbliss]

So I have an update sortof...

I tried a bunch of other files I had printed in the past and it seemed like each layer had at least 1, sometimes 2 or 3 layer shifts each layer when printing. When I googled the layer shifting problem, 1 thing mentioned was overheating of the main board so I decided to check the fans inside.

Well, as I was tipping the printer on it's side, the print nozzle slid all the way over as if there was no resistance from the x-axis motor at all. Would this be normal? I wouldn't think so.
This is leading me to believe that the motor is bad and the improper x-axis movement is due to the weak motor not being able to move the print nozzle all the time. I've also seen that a bad x/y axis cable can cause jittery movement as well so I think I'm going to hit ebay and see if I can find a new motor and cable.