Did I break my hot end?

[TehStranger]

Also, I tried pushing it back in and heard a click noise, but it still comes out with very light pulling or pushing (when I put filament through)

[Geoff]

Also, I tried pushing it back in and heard a click noise, but it still comes out with very light pulling or pushing (when I put filament through)

There is supposed to be a thread that screws into the heatsink... to me it looks like you have barely any thread at all.. it can't be tapped since there is no meat left... hmm I personally would go and spend $50 on a new extruder

[TehStranger]

There is supposed to be a thread that screws into the heatsink... to me it looks like you have barely any thread at all.. it can't be tapped since there is no meat left... hmm I personally would go and spend $50 on a new extruder

this part you mean?

[TehStranger]

There is supposed to be a thread that screws into the heatsink... to me it looks like you have barely any thread at all.. it can't be tapped since there is no meat left... hmm I personally would go and spend $50 on a new extruder

Do you know of any good hot end I should look for?

[Mjolinor]

Any recommendations?

You just quoted his recommendations. Go and buy a new one.

Unless there is some reason why you can't in which case you need to pull it apart and see where it is broken.

[TehStranger]

You just quoted his recommendations. Go and buy a new one.

Unless there is some reason why you can't in which case you need to pull it apart and see where it is broken.

oops. What I meant was does he have any suggestions for a hot end. I'll edit that now lawl.