Results 1 to 8 of 8
Thread: Filament suggestion
Threaded View
-
05-01-2022, 12:10 PM #7
probably a spammer, but no links I can find.
I find with pla, the gentle appliction of a rubber mallet often overcomes inflexibility.
Unless you actually want to take it apart again - then, go with something more bendy like petg :-)
But it bend more often than it breaks.
ASA I haven't tried properly. I did test some and it smelt as bad as abs, so didn't bother going any further.
But pla will generally give, with enough applied force :-)
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion