Can anyone make this model printable?

[fred_dot_u]

You are correct about the borked. Pretty amazing failure on the model, but Windows 10 has 3DBuilder with a surprisingly good repair facility. First photo shows Meshmixer's Analysis/Inspector results, while the second one shows the results in Meshmixer after 3DBuilder did its thing.

You're also right about the dish. I chopped it off to get a fast easy measurement and it's tiny compared to the 200 mm overall length of the vessel. That's a part better suited for resin printing.


This is Meshmixer's analysis. It looks like a sea urchin, with all those "spines." I didn't even try using Meshmixer's built-in repair facility. I felt the entire model would disappear as a result.



The "after" version shows no problems at all.



Here's the dish after it's been excised.