Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 10

Threaded View

  1. 01-02-2022, 06:53 AM #10
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,153
    Add Roberts_Clif on Thingiverse
    Airkout

    Posting the Cura Profiles created and use daily to 3D Print using a .4 nozzle up to .32mm successfully.
    .32mm is max layer height at 80% of the nozzle diameter.

    Give them a try and see if any will help your 3D Printed models.

    For Cura 15.04.6 / creality slicer 4.8.2

    If these profiles work and you want to try PrusaSlicer will post profiles or the Newer Cura versions Profiles

    Sample 3D Printed Model below using single extruder printer.

    Landing Pad.jpg
    Attached Files Attached Files
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules