Results 1 to 10 of 18
Thread: Command Line Communication
Threaded View
-
08-24-2014, 05:06 PM #17
- Join Date
- Jun 2014
- Location
- Australia
- Posts
- 18
You'll need to make sure whatever your printer is receiving is in X3G, so unfortunately you probably cant take output directly from Slic3r/Cura.
I know the guys developing MatterControl are looking at adding X3G support in the future, (and it can use Slic3r/Cura) so the dream may become a reality in the future.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion