Results 1 to 1 of 1
  1. #1

    Very rough edges prints

    Hi everyone, this is my first time posting in this forum.Recently i have been 3D printing non-stop lately, it was perfect in the beginning, but my prints are coming out worst and worst, i have fiddle around w/ the settings, but it looks like there were not much improvment i'm using simplify3D to prepare the file, Extruder temperature @ 220°, speed @ 4800mm/min for PLA.

    Please advise what else i can do to improve the print. Thanks in advance!

    edit: fiddling the temperature and speed only in settings
    Attached Images Attached Images
    Last edited by yellowmp5; 11-17-2021 at 07:54 AM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts