Results 1 to 4 of 4
Hybrid View
-
04-01-2022, 07:37 AM #1
There is many you-tube videos as I started I too was a newbie, using You tube videos.
I found one piece at a time learning as I built the attached model below.
If I can do this anyone can..
New Case Layout.jpg
Started with a rectangle block, howled out the inside, contoured the corners... ect... ect...
Until I finally designed this snap together controller case for my 3D Printer using Fusion 360 free for hobbiest.Last edited by Roberts_Clif; 04-01-2022 at 07:43 AM.
ABS Sticking to Build Plate
10-20-2024, 05:02 PM in 3D Printer Parts, Filament & Materials