Results 1 to 1 of 1
  1. #1

    Possible inconsistent extrusion on the Ender 5

    Bought a roll of loneessl filament and getting weird parts where I think there is barely any extrusion in spots. I tried increasing the extrusion multiplier until there was too much and no luck. The filament isn't being grinded. I just to make make sure its not a user error before going after the filament maker.
    Attached Images Attached Images

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts