Results 1 to 10 of 21
Hybrid View
-
08-07-2014, 10:56 AM #1
- Join Date
- Aug 2014
- Posts
- 25
I pulled the trigger on the makerfarm 10". See how it goes.
-
08-07-2014, 10:58 AM #2
-
10-19-2014, 06:58 PM #3
- Join Date
- Oct 2014
- Posts
- 7
-
10-20-2014, 09:39 AM #4
- Join Date
- Aug 2014
- Posts
- 25
been going good, had some issue of the wrong firmware being on the ramps. had the 8" firmware. once i changed it my bigger prints were not getting cut off. i later printed out a different z end stop to make it easier to get the extruded height from the bed easier. after i did that and did a lot of printing and than added auto bed leveling. which made a huge difference for me in time to get ready to print. before you have to manually level out the bed which can be a pain especially after every print.
i could not find the first z endstop i printed out. that little upgrade made it less frustrating to level the bed
auto bed leveling from thingiverse
http://www.thingiverse.com/thing:335632
if you do it follow the guide on thingiverse as far as what to print and what to buy. than you will use zennmaster guide on setting up marlin.
not to hard to get going but it was worth it.
questions or issue just let me know.
-
10-21-2014, 12:26 PM #5
- Join Date
- Oct 2014
- Posts
- 7
you will not be sorry,i love mine
Ender 3 Neo - Jam Problem
05-08-2024, 03:06 PM in Tips, Tricks and Tech Help