Results 1 to 4 of 4
Thread: Anycubic Vyper issues
Threaded View
-
08-09-2021, 06:47 AM #2
what filament are you using ?
But looking at the poicture - the nozzle is too far away from the bed.
You might also have a little blockage in the nozzle. And p[ossibly printing too hot.
If you have bed levelling knobs - convert to use nylock locking nuts.
That pretty much eliminates bed levelling issues. level once and then never bother again :-)
How are you levelling the bed ?
ie: how thick a piece of paper/card (never use card) are you using ?
Also what is your first layer speed.
And if you don't know - that could also be part of the problem.
You need to know the actual mm/s print speeds - not some random percentage that some slicers give.
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials