How do I draw this in 3d?

[dexyweescot]

Export it as an archive file. I think it's the top option. Save it locally then send me the file in a message bud.

[Reinoud]

Export it as an archive file. I think it's the top option. Save it locally then send me the file in a message bud.

Thanks for the tip, so far no problems. However I haven't found out yet how to send you the file. I don't know if it's possible on this forum.

[dexyweescot]

Could simply upload to your cloud and send a link..

[dexyweescot]

I think I read it wrong and your wanting the sleeve to go over the nozzle then use a knife. You have to mind and use material thickness so your inside of your sleeve will be the outside of the nozzle. I see your tip has 14mm diameter at the top. if you have a 1mm wall then it will obviously be 12mm inside that then gets cut. Send me the dimensions that you want the finished nozzle to be.