abs filament curl upward

[Geoff]

abs white, 230 ex, 110 hbp, with raft, no support,

You have 2 problems..

1. See your raft layers are all seperated in some spots and joined in others? level your bed again. Some of your raft is dead flat, meaning you are printing too close in some sections.

2. Lower all your temperatures. If you are getting curling off a raft (and this I have very rarely had happen...) you are just too hot.

Try 226c and 106c on the bed and see what happens.

Also raise the layer height, if youa re printing at 0.2mm, raise it to 0.25mm and if you are printing at 0.25 raise it to 0.3mm and so on. Thicker prints stick easier.

To get lifting like that from the raft