I use a MakerGear M2 with ploymide tape on the glass bed. I print ABS at 235C, enclosure is at 50C and the bed is 110C
My parts are all designed with rounded corners if possible. Z offset is set with bed and enclosure at temp, the bed will change shape when at 110 vs 70 and offset will need to be adjusted for perfection that is required for ABS to stick well. I also will use a skirt on and abs part.. 4-6 outlines depending on nozzle size spaced .03mm from the part so it can be removed without too much fuss.. Also I have found parts that are very high in infill will warp more than ones that are not.
Good luck!