Warping, Ultimaker 2

[kallisti5]

Hm. I'm seeing a lot of folks running much higher bed temperatures. The 80C is default on the Ultimaker for ABS. I'll try the same print/filament and raising to 94C and pre-heating a bit longer. I'd like to get reasonably good at printing reasonably square items without mouse ears, brims, etc. Thanks!

[Bikeracer2020]

Don't forget, no part cooling fan.

Few days ago I had some PLA warp up off the bed. Moved bed temp from the recommended 45 up to 60, that cured the warping off the bed.

I've gone right off PLA, I get a much better finish with ASA.