I did as you recommended and printed a calibration print. Came out well except for the same stringing bits. See off the side of the numbers I have a build up which looks to be the same as on the vase. On this though, I can cut these off and no one would know better. On the vase, they are sticking to the curved parts and then impossible to remove.

PXL_20210701_104529969.jpg

Is this just stringing clumping together or does this look to be something else (hoping more experienced 3D printers will know what this is)? I am currently printing something else and have changed my retraction settings to retract a bit faster and a bit further to see if that helps. Also dropped my temp to 235'c to see if that helps with the strining too.

Any additional insights from anyone would be helpful!

Thanks again

Ben