@airscapes
I’m looking specifically at the Taulman 910 high temp one. I’m looking to print a number of parts for various other hobbies, but one part will be a bracket that’s going in the engine compartment of a car. Therefore I am aiming for the high temp version – it’s said that they have a 150C thermal resistance after annealing. There is the Taulman PA Cast Plate Nylon, with a supposed 185C thermal resistance after annealing, but since the filament is so new, I can’t get much confirmation or information about it.

The Polyimide tape appears to show some promise, but cover a glass plate with a narrow roll would leave lines on a printed model’s surface?


Something like this:

https://www.makergear.com/collection...20387220586594

seem better, but then it starts getting into the price issues since I’d have to cut it to size (235mmx235mm)

Has anyone printed nylon on glass with just PVA? I know Taulman suggest that for their filament, but it doesn’t appear like anyone I encounter on forum or YouTube does that.