Quote Originally Posted by rongee View Post
Hi, back again. Took a few days off for Father's Day.

Yes, the Sapphire Plus has 2 Z-axis motors, and if by "dual endstops", you mean 2 z-axis limit switches, yes, it's got that. But, if you use the 3D Touch that is provided, it plugs into one of the z-axis limit switch spots on the motherboard, and so you can't use both.

I had to make a cable for the 3D Touch because the one provided had the wrong connectors and wasn't long enough. That's done.

There's a Youtube video I'm following right now for the installation and they also said that the setting in the firmware were incorrect. They have a whole 2nd video and converting to Marlin. They also said that some problems went away once Marlin was up and running.

Ron
https://www.youtube.com/watch?v=BDtZPNZ5xks
This video shows the G34 auto alignment. This can actually be done without any Z-limit switches, just using the BLTouch. Mine is setup to use just a single induction probe for everything.