Noob here, just got a flying bear ghost 5, and can't seem to level the board correctl

[curious aardvark]

well you only waited 2 hours.
Not sure you have the patience for 3d printing :-)

But essentially the print nozzle is too far from the bed.

You either need a thinner piece of paper or need to adjust the z axis offset in the slicer.

basically the print nozzle needs to be closer to the printbed.
Looking at the bead I'd say 0.15-0.2 mm closer should do it for a decent adhesion.

Assuming you haven't sent it back yet ;-)

[Solstar]

I haven't sent it back yet, because i managed to get some modicum of calibration.

almost

https://imgur.com/a/5Stu2SI

i printed the nut and bolt example and seems to be printed out very nicely though