I bought a Creality Ender3 a couple of years ago and still can't believe how something I paid less than $200 for does such amazing prints. I have two complaints: The least complaint would be the scrolling on the display. Sometimes it won't scroll at all and other times it scrolls past the choice I want. I can live with that. The biggest complaint is the tiny little slot that I'm forced to thread my microSD card into. I just hate it and don't know why they haven't upgraded to something better and offered a retro-fit for those already sold. I've seen all the different mods for using the long ribbon cable so that you have the micro end plugged in all the time (assuming it latches and it usually doesn't), and an SD card slot on the other end. To me, that's a pretty clunky way of fixing something though I may eventually do that. But what I'd rather have is a whole new board if necessary. Better yet would be a small adapter that stayed plugged in (the micro end) and actually did latch, and a female side that would take a full size SD or USB. Do any of you know of anything like that? Any suggestions would be appreciated.