Results 1 to 10 of 18
Thread: Slicers and Quality
Threaded View
-
05-06-2021, 12:16 PM #8
Was looking for this could not find so did not post previously
Tablet Holder.jpg
While 3D Printing this Laptop Stand at .28mm layer height i find that the area shaded in green has a texture as that of stairs.
Using PrusaSlicer I can change the layer only in this area, this allows the model to be printer in record time without the stair-step texture.
Laptop Holder.jpg
This model was one I was helping another user configure using PrusaSlicer.
I was using his model for proof on improving the model texture while keeping a low print time.
If a smoother print surface was desired a more extensive configuration could have been easily used to make it smoother.
Please explain to me how to...
Yesterday, 12:15 PM in 3D Printer Parts, Filament & Materials