Results 1 to 10 of 103
Threaded View
-
05-10-2021, 03:25 PM #11
- Join Date
- Apr 2021
- Posts
- 70
I'm not sure the TL-D3 Pro has a way to raise or lower the bed other than through loosening and tightening the corner springs. The Z-axis end stop can be moved up or down through software but only at roughly 1 cm jumps. If there is another way it's not all obvious.
When I finally got things properly levelled The springs were only 4 to 5 turns tighter than loose enough to self loosen so that is unfortunate.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion