Subscribe to Our Newsletter Advertise
Close



Results 1 to 3 of 3

Threaded View

  1. 04-20-2021, 07:07 AM #2
    Gambo
    Gambo is offline
    Engineer-in-Training
    Join Date
    Aug 2020
    Location
    United Kingdom
    Posts
    249
    Simple answer without support on a fdm printer you can't print it in one piece redesign it to be printed in 3 or 4 parts. print the front and back lying on their inside surface. then the rim in eiter 1 or 2 pieces. Design a ridge on the edge of the front and back to register the side piece and use a 3M plastic superglue to assemble.A lot of hassle alternative GIVE UP !!!
    Last edited by Gambo; 04-20-2021 at 07:16 AM. Reason: addition
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules