Results 1 to 10 of 17
Thread: Slicers and Print Speeds
Hybrid View
-
04-08-2021, 11:18 AM #1
seems about right.
You may well have unrealistic expectations of print speeds :-)
What you could do is to increase the layer height to 0.3mm
cuts the print time by 1/3
And ten minutes with a file gets it as smooth as a 0.2mm print.
Depends on whether you value less post processing over more print time - or not :-)
IF I printed this at my normal settings for non-critical parts. And kept the 0.2mm layer height and upped the infill to 25%.
so:
3 top and bottom layers and perimeters. 0.4mm nozzle and I can do it in 2 hours.
But that's on the sapphire pro 2 at 150mm/s.
And most machines just can't hang with saffy for pure speed :-)
What printer do you have ?
It makes a LOT of difference.
It is a decent sized part, anything under 4 hours would not seem unreasonable.
I'd have been happy with anything under 4 hours for that, before I got saffy.
It would take a lot longer on the delta as I'd need to stand the part on it's end.
Actually it doesn't.
2 hours 38 minutes.
That's standing on it's end, 125mm/s print speed - but the 0.5mm nozzle does make a LOT of difference.
And to be fair the part will be a lot cleaner printed on end anyway.
Although if you have an i3 setup - probably not so much.
With delta, cartesian or corexy tall vertical prints can be printed on faster speeds than with an i3.
So, yep without using larger nozzle or - probably - a different design machine, 3-4 hours is pretty good.
I will add, that I am impatient in this respect and I value functionality over shinyness.
So as long as it's structurally sound, I don't mind a little sanding if it saves me several hours print time.
Although 150mm/s at 0.2mm on saffy is pretty bloody good.
Okay so for comparison I sliced it on the knp - a replicator pro clone.
60mms speed (she will do 75, but not happily) 35% infill, 3 perimeters and layers and 0.4mm nozzle at 0.2mm layer height.
Around 3 hours 50 minutes.Last edited by curious aardvark; 04-08-2021 at 11:41 AM.
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials