Thanks CA.

I'm learning by the hour about each of the three main areas of my workflow: OpenSCAD, Cura and Ender 3 V2. One particular aspect of the former that I'm grappling with is visualising the effects of Difference(), especially when there's a 'hierarchy' of them. With that and Translate() too, I'm too often resorting to trial/error. I'm sure I'm not making full use of the various views in OpenSCAD and Cura.

I was about to give you an example I'm working on right now, but I'll do so later in a separate post with a more relevant subject heading.

But the biggest obstacle is of my own making: impatience to get stuff printed!