Results 1 to 10 of 16
Thread: When to use 'Support' option?
Hybrid View
-
04-06-2021, 12:10 PM #1
- Join Date
- Mar 2021
- Posts
- 63
If you're asking about how to make sure the bottom of your lid will end up right at z=0 on your print bed, there's no issue.
Yep, that was it. I had in mind an arithmetic error - typically when using Difference - going unnoticed, placing the model above the base.. But I've now learnt how to select a surface in Cura and elect to have that on the base.
Ender 3 Neo - Jam Problem
05-08-2024, 03:06 PM in Tips, Tricks and Tech Help