Can I make several identical prints in the same run?

[Axl_Myk]

What profile in the slicer are you using? Standard ought to be fine.
Scad creates the .stl file. Load that into the slicer (Cura) and copy the item there.

[terrypin]

What profile in the slicer are you using? Standard ought to be fine.
Scad creates the .stl file. Load that into the slicer (Cura) and copy the item there.

For this (my first print) I used Creality Slicer. There was no option to choose Ender 3 V2 so I used 'Ender—3/Ender-3Pro/Ender-3-3S'. I used all other settings defaults.


Attachment 16101

https://www.dropbox.com/s/piewvtmasm...mate.jpg?raw=1

As you see, its print time estimate proved wildly high.

But as some others have said 3h22m was far too long, please advise what settings I should change?

I've had recommendations to use Ultimaker Cura instead, which I've now installed. At first sight I see no significant difference. It too has no setting for V2. And its estimate was almost identical (over twice as long as the actual print).

Attachment 16102

https://www.dropbox.com/s/upz76wywu6...mate.jpg?raw=1



If anyone else has printed this box, with similar dimensions to mine (10 x 5 x 4 cm), what was the print time?

Attachment 16103


https://www.dropbox.com/s/0lyoaps8ni...gLid.jpg?raw=1


EDIT:
All three images are OK here in Preview, but when I opened after sending they had all been replace with 'Attachment 16101', etc, and a message said Invalid.

I've just sent again and it's still the same.

So I've now added links instead.

Can I get some feedback please?


Terry