Quote Originally Posted by AutoWiz View Post
I thought I was very clear in my quote for 'a whole lot of money', lol. But you did say $2k budget. And I can build that. I mean we will still have my labor to deal with over and above that but I could put 2k into a rig without breaking a sweat. I mean we could put a grand into rails, half that into an extruder and that same amount again into a good frame and thats 2k right there. I am a little over 3k into the Multi Widow. It is a good feeling owning and using a high dollar rig. In this crazy world where so many think their skills or wit can somehow trump a poorly made cloned part the actual reality is these printers are no better than the sum of their parts and a lot of people don't seem to understand that poor quality metals rust easier and faster and that rust pits the metal bearing surface. It's not always a matter of grinding on this or that the cheap stuff is all around cheap. Even with the very materials it is made from. And every company that manufacturers these printers does so with the absolutely lowest price parts they can source which both keeps the price down and also keeps them from seeing the reliability they need to break into the land of mainstream. To buy any off the shelf printer is to scrape the bottom of the barrel in the land of 3d printing just for this reason. And it is also why the best machines you will see are the ones built by enthusiasts like me.
Sounds like I would be going over my budget of $2k and I am not sure if I would get support.