I liked my bltouch on my Ender 3 Pro right up until I didn't...lol
For some reason, it stopped probing correctly. I removed the bltouch and manually leveled and all was well in the world.
Later, I decided I wanted a probe again, so I installed a spring steel sheet and an inductive probe, which was much harder to configure working firmware for, but again, it worked well except that it was printing about an inch further right, which would be my own error in the firmware I'm sure. But I eventually got tired of that and again removed the probe.
It always worked best for me with no probe and manually leveled. But I did like the spring steel sheet, Microswiss direct drive, and SKR mini E3 board I installed. The person I sold the printer and all upgrades (installed and not) says he loves the printer and is still enjoying it.
I would suggest uninstall the probe, manually level, and just take your time. It can be a great printer when properly tuned.