Results 1 to 10 of 15
Thread: Calibration question
Hybrid View
-
02-12-2021, 02:45 PM #1
Thanks for the further ideas.
To move 130mm, I pressed 13 times on the +10 button in Repetier host.
I checked my slic3r settings, i could not see any additional code in there that would change the dimensions of the part before slicing.
I checked my print head, if I pull hard on it, I can move it by about 0.5mm maybe, but I can't think of anything that would put that kind of force while printing.
Belts are not too tight, i can press on them and that still feels soft.
I searched for M92 in my last gcode file, could not find any.
Very weird issue. I posted a message too in the vendor forum.
New to 3d printing looking for...
Yesterday, 12:56 AM in Tips, Tricks and Tech Help