Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 15

Hybrid View

  1. 02-11-2021, 11:06 AM #1
    Snow_Man
    Snow_Man is offline
    Student
    Join Date
    Feb 2021
    Location
    USA
    Posts
    5
    Add Snow_Man on Thingiverse
    As fred said, print a square calibration cube. You can adjust the X and Y steps independently, depending on the motherboard, directly through firmware or through inserting a line of GCODE as correction at the start of each print.
    Reply With Quote Reply With Quote
  2. 02-11-2021, 02:14 PM #2
    Hugues
    Hugues is offline
    Engineer-in-Training Hugues's Avatar
    Join Date
    May 2014
    Location
    Switzerland
    Posts
    219
    Yes, good idea, i will do that
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules