Results 1 to 5 of 5
Thread: Help ! Creality Cr10 Pro
-
02-07-2021, 02:40 AM #1
- Join Date
- Feb 2021
- Posts
- 6
Help ! Creality Cr10 Pro
Hi - This is my fourth print following a clicking filament drive problem? I cleared the nozzle, made sure the feed tube was correctly inserted into the hot end. It printed the raft good, I think?, then the deformation started to happen? the nozzle even scrapped across the filament ? Any thoughts as to what is going on? Please see pic attached.
Last edited by bullet11300; 02-07-2021 at 04:00 AM.
-
02-07-2021, 06:06 AM #2
Post the filament are you using and at what temperature are you trying to 3D Print.
-
02-07-2021, 06:43 AM #3
- Join Date
- Feb 2021
- Posts
- 6
Makerbot PLA 200 degrees
-
02-07-2021, 06:44 AM #4
- Join Date
- Feb 2021
- Posts
- 6
I am noticing that raft or not the first layer is patchy, not joined in the direction of print.
-
02-07-2021, 02:31 PM #5
This could note under extrusion, though your raft is looking good.
Is the print speed or temperature changing during print.
I started with PLA printing a 192C now printing PLA at 208C
Please explain to me how to...
Yesterday, 02:43 PM in 3D Printer Parts, Filament & Materials