Results 1 to 1 of 1
-
02-04-2021, 03:05 AM #1
- Join Date
- Feb 2021
- Posts
- 1
Blobbing and Layer Delamination with Creality LD-002R
Good Morning all,
First post so here we go..
I have to issues,
- First picture you see the base on my prints get "Blobbeb", best way I can describe
- Second picture looks like layer delamination, see the squares on the right and top sliding off the print.
These are files sliced with Chitubox, 2 resins used is Anycubic Clear and Monocure 3D Rapid
Both I've gone from 4 seconds per layer up to 12 seconds per layer, 10 base layers with 60-100 seconds cure, both resins do this so I can't imagine it being a resin issue?
But then I can't think what else, levelled the print bed 5 times now, all looks good,
Any ideas??
Thanks!
Dion
IMG_8766.jpg IMG_8807.jpg IMG_8806.jpg
New to 3d printing looking for...
Yesterday, 12:56 AM in Tips, Tricks and Tech Help